Dongguang Fuchen Electronic Technology Co., Ltd.Welcome to visit

中文english

Service hotline:
0769-88032187

    Information

  1. Contact person: Mr he
  2. Tel: 13825780565
  3. Landline: 0769-8803187
  4. Address:Gaoke 5 Road, Xinlian Village,Humen Town,Dongguan,Guangdong,China
How to clean the remote control?。
9/05 2018

the remote controller can be scrubbed with cotton swab dipped in anhydrous alcohol or special cleaning agent such as Freon, and then dried by electric blower or left to dry.
Some keys of the remote controller are ineffective and no signal is sent out. Such faults are mainly caused by dirt adhering to keys or conductive rubber. Scrub the circuit board and conductive rubber with anhydrous alcohol or special cleaning agent, and blow dry or dry with an electric blower to eliminate the faults.

1. The painting of the circuit board does not dissolve in alcohol and will not melt and fall off due to washing with alcohol;
2. Alcohol does not contain electrolyte and will not produce conductive short circuit;
3. Alcohol can wipe away greasy and deposited dust to make the circuit board bright and clean as before.
4. Alcohol volatilizes easily and dries out in a ventilated place for a few minutes without residue.

Cleaning method: After the circuit board is removed, it is best to blow off the floating dust with a hair dryer, then use a soft brush to brush off the adhered dust and the dust in the corner inside, then gently wipe it with alcohol cotton yarn and dry it in a ventilated place.

Note: Do not wash with water or other solvents, and do not soak to avoid damaging components on the circuit board.

    LINKS:

  1. Link
  2. Link
  3. Link
  4. Link
  5. Link
  6. Link
  7. Link
  8. Link

Copyright belongs to Dongguan Fuchen Electronic Technology Co., Ltd. 粤ICP备18062922号-1 (技术支持 中国万创网)

About Products dial Navigation